IGET Bar Plus S3 Manual: Setup, the Button and Changing Pods
IGET Aus · Updated 8 September 2026
The IGET Bar Plus S3 is the rechargeable pod version of the Bar — the same device we list as the IGET Bar Plus. It comes with less documentation than it deserves, so here is the practical version.
Setting up your IGET Bar Plus S3
Unbox the device and the pod, peel the seal off the base of the pod, and press the pod into the top of the device until it seats. Give it a minute or two before the first draw so the wick can absorb liquid — skipping this is the most common cause of a burnt first puff. Then draw on the mouthpiece.
What the button on the IGET Bar Plus S3 does
The S3 is primarily draw-activated, so for normal vaping you do not need the button at all. Where it earns its place is as a check: a press typically wakes the display or indicator so you can see battery and pod status without taking a draw. If your unit has a display, that is how you read remaining charge at a glance.
How to change an IGET Bar Plus S3 pod
Pull the used pod straight up and out — it is a friction fit, so it comes away with a firm, even pull rather than twisting. Peel the seal from the new pod, press it in until it seats, and wait a minute before drawing. Keep the old pod upright until you can dispose of it, because a used pod still holds residual liquid.
Because the battery stays with you, swapping S3 pods is how you move between flavours cheaply. See every blend on the IGET Bar flavours page.
Charging the S3 safely
Standard USB-C cable into a normal low-output port — a laptop port, a power bank or an ordinary phone plug. Avoid high-wattage fast chargers, unplug when it reads full, and never charge it unattended or overnight. The same rules we set out for charging the Bar Pro apply here.
If the S3 stops working
Reseat the pod first, since a pod that is not fully home is the usual culprit. Then charge it, in case the battery is simply flat. Then check the contacts on the device and the base of the pod for liquid or lint and wipe them dry. If a pod tastes burnt, it is spent — fit a fresh one.
Get the S3 kit or stock up on pods. Both in stock, dispatched same day Australia-wide.
Shop IGET Bar Plus S3 →FAQs
Is the IGET Bar Plus S3 the same as the IGET Bar Plus?
Yes. The S3 is the IGET Bar Plus. It is the rechargeable pod device that takes swappable flavour pods.
What does the button on the IGET Bar Plus S3 do?
The device is draw-activated for normal vaping. The button typically wakes the display or indicator so you can check battery and pod status.
How do I change a pod on the IGET Bar Plus S3?
Pull the old pod straight up and out, peel the seal from the new one, press it in until it seats, and wait about a minute before your first draw.
How do I charge an IGET Bar Plus S3?
With a standard USB-C cable in a normal low-output port. Avoid fast chargers and unplug once it is full.